Electrical power UNITS FOR LIFT TABLE 1
Basic Description
This energy unit is created solely for your smaller lift table,Consisting of large strain gear pump, AC motor, multi-functional manifold, valves, tank, and so forth. This power unit is widely used during the business of logistic units for instance minifork lift, scissors lift and ariel working platforms. The lower-ing motion is controlled from the solenoid valve with all the speed controlled through the adjustable needle valve.
Power UNITS FOR LIFT TABLE 2
Common Description
This power unit is intended solely for that medium lift table, Consisting of really effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The lowering motion is actived from the solenoid valve plus the pace managed from the adjustable needle valve. Once the lift rises to a substantial positoin, but the electrical power supply is lower, the reducing movement is managed through the manual override perform.
Electrical power UNITS FOR LIFT TABLE 3
General Description
This electrical power unit is designed solely to the large lift table, Consisting of extremely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing movement is actived from the solenoid valve as well as pace managed by a pressure compensated movement control valve.
Electrical power UNITS 
FOR LIFT TABLE 4
Standard Description
This energy unit is designed exclusively for your big lift table, Consisting of hugely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing movement is actived by the solenoid valve and also the pace managed through the adjustable needle valve. When the lift rises to a higher positoin, but the power supply is lower, the decreasing motion is controlled by the manual override function.
Special Notes
one. This electrical power unit is of S3 duty cycle, which can only perform intermittently and repeatedly, i.e. one minute on and 9 minutes off.
two. Clean all of the hydraulic components concerned before set up of the energy unit.
three. Viscosity on the oil shoud be 15~46 cst,which need to also be clean and free of impurities.N46 hydraulic oil is proposed.
4. Oil changing is needed following the preliminary 100 operation hours,afterwards the moment just about every 3000 hours.
five. The electrical power unit shown is intended to be mounted vertically.
